Tel: +86-592-8996369
Home > Knowledge > Content
Categories

Add: 5FL Chuang Ye Building, Chuang Ye Park, Torch High Tech Industrial Zone, Xiamen, China
Post Code: 361009
Tel: +86-592-8996369
Fax: +86-592-8952068
Mob: +8613779950997
Contacts: Mr. Yang
Email: orythcom@hotmail.com


Easily address the plug soap dispenser problem

Oryth Industrial China Limited | Updated: Dec 03, 2016

First open the SOAP dispenser lid, then remove pump from base. If there are anyother objects in the SOAP from the container, then be separated and removed theobject. Do not force any demolition or dismantling the pump head.

Second, fill the hot water tank, sink, placed on the pump components. Soak for a few minutes the pump.

Third, use a scrub brush or toothbrush to scrub the pump, in particular at the connection point and the pump head. This will remove any SOAP residue.

The four, from the faucet flushing pump hot water through a straw.

Five, reassemble the pump top, and reinstall it into the container.

Six test pump top, see if you can make SOAP and hot water through.

Seven, use a paper clip to clean the pump head. Straighten the paper clip, and dismantling it through straws. Use SOAP residue removed from the pump head.

Eight, by flushing the pump head from the leading a lot of hot water to remove any remaining residue.

IX, rinse all the components, as well as the SOAP from the container.

Ten, fill the container with SOAP and reassemble the pump, pump head and reinstall.